Anaerobic Adhesives

These are mechanical maintenance and manufacturing based products.

They cure in absence of air taking metal as a catalyst.

The Anaerobic range of adhesives consists of

Thread Lockers

Bearing Retainers

Gasket Eliminators

Hydraulic / Pipe Sealants

Thread Lockers

· These are Anaerobic liquids i.e. curing in absence of air taking metal as a catalyst.

· These are semi permanent adhesive sealant meant for thread locking.

· They are used to prevent loosening of Nut – Bolts due to vibration, impact or pressure during service.

· Its service temperature is from –60 to 150 deg. C

· It gives an incremental torque value of above 20% of the installed torque with pressure resistance upto 6000 psi.

BACK

Bearing Retainers

· These are Anaerobic liquids i.e. curing in absence of air taking metal as a catalyst.

· Bearing retainers are semi permanent adhesive sealant.

· They are used to prevent slippage, wear and tear of bearings due to vibration, impact or pressure during service.

· It can fill up gaps upto 8 thou thus supporting slip fit type of bearing fixing and avoiding interference fit.

· Its service temperature is from –60 to 150 deg. C

· It can withstand pressure upto 6000 psi.

BACK

Gasket Eliminators

· This is Anaerobic paste that cures in absence of air taking metal as a catalyst.

· These are semi permanent adhesive sealant ideally meant for eliminating mechanical gaskets on machined surfaces.

· This paste when applied in a bead form on the Flange surface and with the joint bolted firmly, forms a gaskets, thus it overcomes the problems of holding stocks of gaskets of different shapes & sizes.

· Its service temperature is from –60 to 200 deg. C

· It can withstand pressure upto 6000 psi.

BACK

Hydraulic / Pipe Sealants

· This is a Teflon based Anaerobic paste that cures in absence of air taking metal as a catalyst.

· These are semi permanent adhesive sealant ideally meant for hydraulic joint sealing.

· Being a paste it overcomes the problems of shredding / cutting and in turn choking which takes place in the use of Teflon tapes. Over and above it gives prefect sealing against vibration, impact and pressure during service.

· Its service temperature is from –60 to 200 deg. C

· It can withstand pressure upto 6000 psi and gives an instant sealing upto 250 psi pressure.

BACK

Back to Product Range Introduction Page

Home

This information has been collected by carefully investigation and serves only as a guideline for application. Due to the number of possible application methods, we do not assume responsibility for any particular technical result.